Why should the gas boiler water be softened?

Why should the gas boiler water be softened?

When the boiler is in the auxiliary machine configuration, the water treatment will be placed in the first place. What is the meaning of water treatment?
Simply put, boiler water treatment refers to pre-softening the water flowing into the boiler and then flowing into the boiler for related use.
Natural water contains various salts. These salts are dissolved in cations and anions, mainly composed of calcium and magnesium ions, and are collectively referred to as "hard water". The minerals contained in these hard water boiled in the container and gradually form a white block or powdery solid, which is what we often call "scale".

First, the main hazard of scale.
       1. Due to the extremely poor thermal conductivity of scale, heat absorption is reduced during heating, boiler thermal efficiency is reduced, fuel utilization is reduced, and boiler operating costs are increased. 2. Fouling will cause the temperature of the furnace wall to increase exponentially. The stress of the steel is destroyed and the strength is reduced. In severe cases, the bursting phenomenon will occur, which will seriously reduce the service life of the boiler.
         2. The calcium and magnesium ions in the water will be integrated into the water during the heating process, which will directly affect the steam quality. At the same time, if the boiler parts such as safety valves, pressure gauges and pressure controllers are scaled, it will cause blockage.

Second, the method of water treatment.
       Boiler water treatment usually uses a combination of a resin tank and a salt tank. When the raw water containing hardness passes through the resin layer of the exchanger, calcium ions and magnesium ions in the water are adsorbed by the resin while releasing sodium ions. The water that flows out of the exchanger is the demineralized water from which the hardness ions are removed. When the resin adsorbs a certain amount of calcium and magnesium ions, it must be regenerated. In the regeneration process, the resin layer is washed with a high-concentration sodium oxide solution in the salt can, and the hardness ions on the resin are replaced, and the resin is restored to the softening exchange function as the recycled waste liquid is discharged out of the tank.

Third, on-site practice.
       1. Check the inlet water pressure (0.2-0.4MPa); check whether the high-concentration brine in the pipe is sufficient; check whether the salt pipe and the sewage pipe are blocked; if there is any abnormality, start it after cleaning.
         2. Close the tap water bypass valve.
       3. Open the salt water inlet pipe valve and open the outlet pipe valve; open the demineralized water to the soft water tank manual and electric valve.
       4. The control valve is energized and the cycle water quantity parameter is set.
       5. start running.

company news