Do I need to report to the relevant authorities when installing the atmospheric hot water boiler?

Do I need to report to the relevant authorities when installing the atmospheric hot water boiler?

Atmospheric pressure hot water boiler is a category of boiler equipment. The interior is of atmospheric pressure structure, basically there is no risk of use, and the safety factor is relatively high. So, if this type of hot water boiler is installed and used, do you need to report to the relevant departments and submit materials? Zhengzhou Fangkui Boiler Company will answer your questions.

For boilers such as atmospheric hot water boilers, whether they need to be reported for installation depends on the capacity of the boiler. If it is less than 300,000 kcal, it is not necessary to install the registration; if it is more than 300,000 kcal, it is necessary to report.

However, from the current form, this provision is not static, depending on the policy situation in each region.

The requirements for the height of the boiler during the installation of the boiler are mentioned in the "Boiler Air Pollutant Emission Standard", specifically speaking: the lower limit of the chimney height should be determined according to the total capacity of the boiler room, but the basic The requirement is to be higher than the height of the building. If the boiler capacity is above 28MW, it should be comprehensively considered based on environmental and other factors.

When it is found that the water level cannot be seen through the water level gauge in the boiler, it is possible to perform the flushing work to determine whether the water is lacking or full, and then take effective measures to solve the problem.

company news